Plastic products for daily-use: 28%
Plastic accessories of autos and motors: 16%
Engineering plastic materials, boards, tubes and watercourse accessories: 15%
Plastic products for producing and packaging-use: 10%
Plastic products for agricultural and fishinery-use: 8%
Toys and craftwork, etc: 23%
※ In Taizhou, enterprises in the plastic industry are more than 10,000, and their annual sales reach 29 billion RMB
※ The annual output of the plastic products and accessories amounted to 1.5 million tons in 2004, which took 60% of the national market possession rate, and consumed over 2.8 million tons of raw materials.
※ Situated in the China Daily-Necessities Metropolis, the plastic products market, covering an area of 15,000 square meters, owning near 1000 stalls in which more than 10,000 kinds of products are on show, is the largest national plastic products distributing center with the most abundant products and lowest price.
"Hometown of Moulds"
※ There are more than 2,000 mould manufacturers, totally owning more than 8000 mould manufacturing equipments, including more than 3000 advanced level equipments. The total output value produced by these manufacturers in 2003 reached 8.75 billion yuan.
※ Eleven sets of moulds were granted "National Importance New Products Certificate" by State Economic & Trade Commission, PRC; seventy four sets of moulds were awarded "National Excellence" by China Die & Mould Industry Association; forty two sets of moulds were proved to have reached "International Level" by specialists of Technology Committee of China Die & Mould Industry Association, which counted 42% of the total.
※ Huangyan district was granted the title of "Plastic Mould Industry Base of National Torch Program" by Ministry of Science and Technology of PRC and the title of "Provincial High and New Technology Industry Huangyan Plastic Mould Base" by Department of Science and Technology of Zhejiang province.
The price of plastic moulds manufactured in Taizhou is comparatively lower, which is only 10 percent of that of the same kinds of moulds manufactured in other countries.
|
